Dakota Alert AD-01 Kit Manual de usuario descargar pdf (Pagina 11)

www.EFRrhoades.com • ph: 800.653.2685 • fax: 574.594.5899

Accessories for Driveway AlarmsAccessories for Driveway Alarms

These accessories are compatible with the WMA-3000, the

Hard Wired Vehicle Sensor, the WRH-3000, and the WPA-3000.

Light/Timer Control

The timer control, when activated by our wireless drive alert, is normally

used for security reasons. It has the ability to turn on lights, etcetera,

and can be set to stay on for two, ﬁ ve, or ten minutes then shut oﬀ

automatically. The control unit has an on/oﬀ switch, should you choose

not to use it. Installation is very easy—just plug the timer control into a

standard wall outlet, then plug the timer line cord into the drive alert

receiver. The timer control can turn on up to 250 watts of light.

Loud Ringing Bell

This 6" bell can be used with any of our driveway alarms. This bell can

be used outside, but may also be used inside for those with hearing

problems.

Siren

This siren can be activated by any of our driveway alarms. It can be

used outside, but may also be used inside for those with hearing

problems.

Line Carriers

Line carriers are designed to send a remote signal from

one building to another, providing that all locations

are downstream from one power transformer. Plug the

transmitter into a 110-volt outlet in one building and

through your existing power lines, it will trip the receiv-

er in another building. The transmitter can be activated

by a driveway alarm. A loud bell or light plugged into

the receiver would be activated.

Extra Whistle

The extra 12-volt DC whistle can be connected to the receiver to make it

louder, or it can be located in another room or building by wiring it with

two-strand doorbell wire.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Dakota Alert AD-01 Kit Manual de usuario Pagina 11